Below you will find a detailed list that includes complete rebuilt NP242 Transfer Cases, In addition you will find parts for the NP242 including bearing rebuild kits, gaskets, seals, small parts, bushings & thrust washers, individual bearing, forks and sliders oil pump, planets, differential housing, shafts, chain, sprockets and miscellaneous parts. If you need more information or cannot find the parts you need give us a call, if you would like to save money, ask about our good take out parts (GTO), they are inspected and guaranteed.

Having issues diagnosing problems with your NP242 transfer case?

We can help free knowledgeable technical support! We have a large inventory of rebuilt NP242 transfer cases plus Transfer Case parts. Our factory rebuilt re-manufactured Transfer Cases are tested before leaving the factory. In the beginning New Process manufactured these transfer cases and later they were manufactured by New Venture Gear, mechanically they are both about the same. This model is a chain drive, output is on the driver-side with center rear output. The NP242 was used by AMC in Jeeps before Chrysler took over. The unit has been utilized in XJ Cherokee, Wagoneer and Comanches as well as in the Liberty KJ. General Motors also used this transfer case in the Hummer H1 until 2006, and in their H2 model from 2003 to 2009.

What is the NP242 Transfer Case

The NP242 was manufactured with manual shift, it is a replacement unit for the earlier NP228. transfer case is a full-time, chain drive, 2.72:1 ratio, and has a magnesium case with 4WD low locked, neutral, 4WD high part time, 4WD high and 2WD high. This unit is a popular replacement/upgrade for the NP231. In addition to a rebuilt unit NP242 transfer cases with a 12 month warranty we offer all parts required to rebuild your unit, we have new part and we can provide good used takeout parts to save you money!

Free NP242 Transfer Case parts illustration

Below we provide a NP242 parts illustrations to assist you with the correct identification of the parts you need. Select the parts you require from the the list below and give us a call. To speak to a Drive Train Expert or to place an order call toll free 888-824-2012!

This information tag is located on rear of transfer case near where the driveshaft exits.

Need Stronger Parts?

Midwest Transmission can Cryogenic Treat any shaft or gear. This cryo treatment will add 30% in component strength. Call 888-824-2012 for a quote.

Rebuilt Tested NP242 Transfer Cases 12 month warranty

Below transfer cases have all new bearings, seals, chain and oil pumps.

Rebuilt Overhaul Bearing Kits NP242 Transfer Case

Small Parts Kits NP242 Transfer Case

Gaskets Seals, Orings & Filter NP242 Transfer Case

GASKET & SEAL KITS

GASKETS & O-RINGS

FILTER

Bushings & TH Washers NP242 Transfer Case

BUSHINGS

WASHERS

Bearings NP242 Transfer Case

Shift Forks & Sliders NP242 Transfer Case

FORKS

SLIDER

Pump, Planet & Differential Housing NP242 Transfer Case

PUMPS

PLANETS

DIFFERENTIAL HOUSINGS

Shafts NP242 Transfer Case

SHAFTS

CHAINS & SPROCKETS

Miscellaneous Components NP242 Transfer Case

Click Images to enlarge and shrink

Minimum order $25.00, Shipping and handling charges will be added.