Single Piece Driveline for 2006 Dodge 2500
I have a Dodge 3/4 ton with the 5.9L engine, automatic 4WD.Question: I am currently running a two piece drive shaft on my quad cab long bed. I was hoping to get a quote on an aluminum one-piece drive shaft similar to the one Dodge began putting in some of the newer trucks. The truck is lifted six inches also via six inch front coils and 4-inch taller leaf springs in the rear. Thank you for an assistance you can offer.Answer: We can manufacture for you a brand new single piece aluminum driveshaft that will be high speed balanced before leaving the factory. Utilizing the single piece driveline will allow you to eliminate the center bearing/hanger assembly. Your cost on this unit will be between $550.00 and $625.00 depending on the condition of you core, plus freight. We will need your existing driveshaft setup in order to get the correct dimensions and this assumes that we can reuse your existing slip yoke as this is a Dodge only part.We will provide an final estimate before work is started as soon as your core arrives at the factory.In order to arrange the order and the pickup of your core give James a call toll free 800-444-0755 he can help you. You can see the other Dodge Ram parts we can provide on our website.